This site was made by me Ian stockley & updated 21-
The British Watch & Clock Makers
Guild
Collective Mark
First the clock had to be striped, then a small piece of silver steel cut to fit the hole.
The top of the shaft was then heated to red hot and silver solder used. The
Problem is the lower part of the shaft is tempered so it must not get to hot. Turn to size, polish and drill a new hole
The top of the shaft was then heated to red hot and silver solder used. The
Problem is the lower part of the shaft is tempered so it must not get to hot. Turn to size, polish and drill a new hole
